Sorta overheating/other?

[skyline180000]

Originally Posted by Jonnychadootz

I think I'm gonna opt for the 20-30 min session (cause of the miles) Get it all outta there.


I'm not sure about putting it in the oil, the crap in there may be blocking seal leaks. What do u guys think? (Remember 164K


Obama can suck ma ballz on that 1 unless he wants to come here and rebuild my motor or pay for it be done (I just don't see that happening)

Just messin with the bama shite! dont know about puttin it in the oil dont think i'd try it with that many miles cause it may cause oiling issues IE spun bearings from lack of lube or low pressure at top of motor. if there is no sludge in your engine i would omit seafoam from the oil. 20 to 30 minutes should be good just make sure to almost flood the engine b4 you shut it off or there won't be enough seafoam in the cylinders to do the cleaning!

[01mmmz28]

^ I have seaformed my jeep, it has 177,000 miles on it and it did fine. It will be fine. I normally put half a can into the fuel tank to help clean the fuel pump/fuel filter/injectors, then the other half of the can goes into the crankcase or a vacuum line.

[Jonnychadootz]

Just messin with the bama shite!

I know so was I, just an amusing thought imagining him with 1 of his spiffy shirts doing a motor rebuild (with the fake rolled up sleeves, like he was really gonna do any work)

[poby]

what motor is it? do you still have a check light? is the idle choppy or good?