Re: bad blowby
no, blow by is normally caused by the rings. Either having gapped over time or from being installed wrong. Does the vehicle in question have a PCV system? if so, just remove the PCV check valve and go to lowes and hit up the plumbing section and find the correct diameter double ended female union and hook up both ends of the tubing where the PCV valve used to be and clamp the ends after the install, that will help some, it did on mine. You should really get a real catch can or get the homemade version from home depot or lowes. It is a air compressor filter, made by husky, it has a "in" line and a return line...you need a catch can w/ both for it to be affective.
__________________
2001 Z/28 LS1. Texas speed cam 231/237 598/595 112 lsa, .660 lift springs,7.4 hardened pushrods, lid, LT headers,TSP X pipe,Texas speed "true duels",Richmond 4.10 gears, stud kit, Thunder racing girdle cover, Spec stg 3+ clutch, ARP rod bolts, clevite main and rod bearings, 25% underdrive pulley, SLP 85mm MAF,black ZR1 rims 315/35/17 Nitto DR's, BMR subframes, BMR LCA's, Edelbrock TQ Arm, BMR pan hard bar. LS2 timing chain and gear set, LS6 ported oil pump.... Tuned by R.P.M. Performance. All labor done my ME and a few good friends !!!!
|